Protech Zoom 400 Operations Instructions download pdf (Page 62)

Operating via the REMOTE Connector

Chapter 4 Shooting

A “Memory Stick” or an SDHC card to be used

with this camcorder must be formatted using the

format function of this camcorder.

It is also necessary to format a “Memory Stick” or

an SDHC card for use if a caution message is

displayed when you mount the “Memory Stick”

or SDHC card.

For a “Memory Stick” or an SDHC card that was

formatted with another system unsupported by

this camcorder, the message “Unsupported File

System” is displayed on the LCD monitor/EVF

screen.

Format the “Memory Stick” or SDHC card as

instructed below.

To execute formatting

Select “Media(A)” (slot A) or “Media(B)” (slot

B) on “OPERATION” > “Format Media” in the

setup menu, and select “Execute.”

An in-progress message and status bar (%) are

displayed, and the ACCESS lamp lights in

orange. When formatting is completed, a

completion message is displayed for three

seconds.

Note

In formatting, all data in a “Memory Stick” or MEAD-

SD01, including protected images, are erased and cannot

be restored.

Connection between the camcorder and a

computer

To use a “Memory Stick” or MEAD-SD01 in

which data have been recorded with an XDCAM

EX-series product, establish USB connection

between the computer and this camcorder and

insert it into the slot of the camcorder, or use a

specified USB card reader SBAC-US10.

To use a media formatted with this camcorder in

the slots of other devices

Make a backup of the media, then format it using

the other device.

When the RM-B170/B750 Remote Control Unit,

the RCP-1001/1501 Remote Control Panel, or

other control unit is connected, some camcorder

functions can be controlled from these units.

You can use the RM-B750’s display or a video

monitor connected to the MONITOR connector

of the remote control unit to control the

camcorder by menu operations and monitor the

camcorder picture.

To connect

Using the remote cable (10 m (33 ft)) supplied

with the remote control unit, connect between the

REMOTE connector (8-pin) of the camcorder and

the camera connector of the remote control unit.

When you turn on the camcorder after the

connection, the camcorder enters Remote Control

mode.

You can control menu and recording operations.

For the functions that can be controlled from the

remote control unit, see “Functions That Can Be

Controlled from the RM-B170/B750” on page 65, or

“Functions That Can Be Controlled from the RCP-

1001/1501” on page 74.

Notes

• Remote Control operations cannot be made if USB

connection to the camcorder is enabled.

• Do not connect or disconnect the remote control unit

when the camcorder is on.

The following controls of the camcorder becomes

inoperative when the remote control unit is

connected.

• GAIN selector

•WHITE BAL switch

• AUTO W/B BAL switch

• SHUTTER selector

• OUTPUT/DCC switch

• Buttons and switches to which the Turbo Gain

function has been assigned, including the

• “Memory Stick” and are

trademarks of Sony Corporation.

• “Memory Stick PRO-HG Duo” and

are trademarks of Sony

Corporation.

• “XQD” is a registered trademark of Sony

Corporation.

Operating via the

REMOTE Connector

Adjusting the Camcorder from the

Remote Control Unit

1 2 ... 57 58 59 60 61 62 63 64 65 66 67 ... 194 195

Protech Zoom 400 Operations Instructions Page 62

Comments to this Manuals